Best Way To Clean Bathtub. Scrub until the soap scum, mildew, or grease disappears. How to clean a bathtub.
First, find some dish soap — seriously, just about any dish soap — and squirt it all over the affected areas of your bathtub. For stubborn limescale deposits around faucets and drains, try a 50/50 mixture of calcium, lime and rust remover (clr) and water. Using a sponge or washcloth, wash down the tub and rinse with warm water.
For Cleaning Your Plastic Bathtub, Rubbing Alcohol Is The Best You Can Use.
A baking soda and vinegar paste will also eliminate hard water spots from your bathtub and its fixtures. Baking soda + vinegar paste. Make sure to get the ledge as well as the walls and floor.
If The Stains Seem To Be Difficult And Don’t Get Off With Plain Vinegar, Then Use The Following Steps:
Sponge or spray the clr solution onto the limescale. Mix vinegar with warm water in a bowl; Apply the vinegar liberally to completely cover the affected area.
Showerheads Are Much The Same.
A large bowl or cup for rinsing scouring sponge microfiber towel Let the mixture sit in the bathtub to remove tough stains. Using a sponge and/or soft bristle brush, wash the entire tub.
Let It Sit For A Few Minutes.
Rub with an old rag or sponge and rinse clean. The stiff plastic bristles will deliver a deep clean, even against tough stains. No need to let it sit, as the work will be done as you brush.
Squirt Barkeepers Friend Soft Cleanser In Bathtub.
Use scrubbing bubbles to scrub your bathtub. If you’re bathtub is porcelain or enamel, you can substitute the vinegar for water to make the paste. The mixture should start to bubble after a few minutes, clearing old gunk and debris out in the process.